Combination Of Galvanized Rack Pipe And Galvanized Steel Springboard

Steel springboard is a tool that is used more frequently now, and has many excellent properties, which is inseparable from the production process of steel springboard. There are always many problems in the welding process of steel springboard, and the specific problems are as follows.

1. The steel springboard cannot be pressed down during welding:

During the production process, sometimes the steel springboard cannot be pressed down, mostly because of improper adjustment of welding current, short welding time, and long cooling time. Pay attention to these problems, and you can reduce the occurrence of this problem.

2. Overmelting of the plate during welding:

The reasons for this situation are mostly caused by too long welding time, too much current consumption, and improper system pressure adjustment.

3. Blackening of the hook welding part:

This situation is often found. On average, two out of ten steel springboards will have this problem. You can carefully adjust the welding pressure and strength.

4. Overmelting between the hook and the steel springboard:

This situation is mainly due to the unstable current of the welding tool. Once the current becomes large, it will cause damage to the equipment.

5. Power failure:

The most taboo in the welding process is the sudden power failure, which is mostly caused by the loss of the welding tool pulse signal. There is no other way to deal with this situation, and it can only be used after maintenance.